Peavey Electronics Speaker 48 User Manual download pdf

Processor Settings for Versarray 112Neo & Subs

with VSX 26/48

(also Digitool/Prolinx)

Single VR112 Neo Cabinet w/118 Sub

Front End EQ (before the crossover section) = PEQ –2.0 dB @ 2k, bw= 0.6 (or use

1/3 octave band at 2 kHz set to –2.0 dB);

Infrasonic filtering: 24 dB/oct. LR @ 34 Hz)

Crossover settings:

Woofer= 24 dB/oct. LR @ 2.0 kHz, Tweeter= 24 dB/oct. Bessel @ 3.0 kHz, Woofer

Polarity Normal, Tweeter Polarity Normal

Sub to Woofer Crossover: Sub= 24 dB/oct. LR @ 125Hz, Woofer= 24 dB/oct LR @

100Hz, Sub Polarity Normal, Woofer Polarity Normal

EQ after crossover:

Woofer EQ = PEQ +1.5 dB @ 560 Hz, bw=0.5; PEQ -3.5 dB @ 850 Hz, bw=0.5

PEQ +3dB @ 115 Hz, bw= 2; PEQ –1.5 dB @ 2.2 kHz, bw=.7;

PEQ –2 dB @ 700 Hz, bw=3.0 Woofer Delay = 0.0 ms (none)

Tweeter EQ: PEQ –3 dB @ 2.7 kHz, bw= 0.7; PEQ +2.5 dB @ 4.6 kHz, bw= 1.0;

PEQ +3.5 dB @ 16.5 kHz, bw=1.0 Tweeter Delay = 0.0 ms (none)

Sub EQ: PEQ +4.0 dB @ 50 Hz, bw= 0.7; PEQ -2.5 dB @ 100 Hz, bw= 0.5

Setting up the

Versarray System

1 2 3 4 5 6

Processor Settings for Versarray 112Neo & Subs with VSX 26/48 (also Digitool/Prolinx) Single VR112 Neo Cabinet w/118 Sub Front End EQ (be

Chart for Changes with Number of Cabinets No. of Cabs: 1 2 3 4 6 8 218 Sub Level†: -6.0 dB -2.5 dB -0.5 dB +1.5 dB +4 dB +5.5 dB 12” W

Page 3

Line curvature, or splay between cabinets Splaying the line will tend to require more level increase from the tweeters, and some more cut EQ at 1.8

A word about system low end The above settings will produce a nominally “flat” system. It is currently fashionable for modern systems to have 6 d

Page 5

Amplifier Level Settings: Sensitivity set at –10 dB is recommended when using Peavey CS series amps. All channels set to the same voltage gain, r

Page 6

VSX 48 presets: Input A Out 1: mids ... top pair Out 2: highs Out 3:mids ... middle pair Out 4:highs Out 5:mids ... bottom pair Out 6:highs Out

No comments

Peavey Electronics Speaker 48 User Manual