www.peavey.comPR®15 D Powered bi-amplified two-way speaker systemOperatingManual
10If an extension cord is being used to provide the AC power to the unit, ensure that it is of sufficient current capacity and that it is not also bei
11The system power amplifiers shall have an unfiltered frequency response of 10 Hz to 30 kHz which deviates no more than +0, -1 dB up to rated power,
Enclosure: Peavey PR 15D (domestic)Frequency Response: 47 Hz to 20 kHzLow Frequency Limit (-3 dB point): 36 HzUseable Low Frequency Limit (-10 dB po
1320 50 100 200 500 1k 2k 5k 10k 20kFrequency (Hz)60708090100110dB SPL (re 20 Pa)Amplitude Response (1m On-Axis)Figure 1FREQUENCY RESPONSE CURVES
14NOTES:
15PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTYWhat This Warranty CoversYour Peavey Warranty covers defects in mate
Features and specifications subject to change without notice.Peavey Electronics Corporation • 5022 Hartley Peavey Drive • Meridian • MS • 39305 (601)
2Intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to
3IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electrical products, basic cautions should always be followed, including the following:1. Read t
4PR™ 15DThank you for purchasing the class D powered PR®15D. The PR 15D features a bi-amped power section that provides 150 watts power for the woofe
5FUSE The unit is AC power line fuse protected from overloads and fault conditions with a fast-blow 3.15 Amp fuse. This fuse is located within the cap
6GROUND LIFTSwitches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.PRIMARY INPUT (CHANNEL 1)The primary input is swit
7O P E R A T I N G I N S T R U C T I O N SThe unit must be disconnected from the AC power source before any work is done on it. Refer all se
8Connecting AC Power To The PR®15DThe PR 15D comes with an 8-foot IEC connection AC power cord. If you are using an extension cord or power strip with
9level controls all the way down, and bring them up slowly with the PR 15D volume control set to the desired setting (halfway up recommended to start)
Comments to this Manuals