Peavey PCX-V12 User Manual

PCX-V12PCX-V12True diversityVHF wirelessreceiverTrue diversityVHF wirelessreceiverOPERATING GUIDE

microphone the AUDIO LED indicators will illuminate according to the strength of sound level. If the LEDs do not illuminate or sound isnot present at

IN” input jack of the amplifier or mixer. Adjust the volume controls of the amplifier or mixer to the same desired level, then properly fine adjust th

5. Caution1. Since the installation of the antenna influences the operating efficiency of the receiver, the most important rule is to minimize the dis

HANDHELD WIRELESS MICROPHONEThe Peavey Pro Comm PCX-V12 handheld wirelessmicrophone is a modular design. It also incorporates“Superior frequency track

2. BATTERY INSERTION1. Unscrew the battery cap in a counter-clockwise direction.2. Insert a 9V battery into the battery compartment according to the c

4. When the microphone is not in use make sure to turn it off to extend the battery life. Remove the battery from the battery compartment if the micro

4. Gain Control: Adjusts the input gain to an appropriate level.5. Transmitter Housing: Contains the PCB and battery.6. Battery Status Indicator: Indi

1. Push down on the battery cover to open the battery compartment.2. Insert a 9V battery into the battery compartment according to the correct polarit

3. AF 4-PIN INPUT CONNECTION METHODS1. 2-Wire Electret condenser microphone Capsule2. 3-Wire Electret condenser microphone Capsule3. Dynamic Microphon

SPECIFICATIONS1. Overall: VHF PCX-V121. Carrier Frequency Range: VHF Band 160~250 MHz2. Oscillation Mode: Quartz-controlled3. Channel: 1-channel fi

Intended to alert the user to the presence of uninsulated “dangerous voltage” withinthe product’s enclosure that may be of sufficient magnitude to con

20TROUBLESHOOTING GUIDESymptom Distance Possible PossibleCause SolutionNo AF signal Any low transmitter replace batteryand no RF signal battery volt

NOTES:21

PEAVEY ELECTRONICS CORPORATION LIMITED WARRANTYEffective Date: July 1, 1998What This Warranty CoversYour Peavey Warranty covers defects in material an

IMPORTANT SAFETY INSTRUCTIONSWARNING: When using electric products, basic cautions should always be followed, including the following:1. Read these i

Features and specifications subject to change without notice.Peavey Electronics Corporations • 711 A Street • Meridian MS • 39301 • (601) 483-5365 • F

INTRODUCTIONThank you for selecting a Peavey Pro Comm PCX-V12 quartz controlled single channel true diversity wirelessmicrophone system. Before operat

1. Antenna Input Connector A2. Power Switch and Indicator:When the switch is turned on the red indicator illuminates to denote normal power status.3.

7. DC 12V Input Jack: Connect the 12V DC plug from the AC/DC adapter.8. Balanced Audio Output Jack: XLR type connector9. Unbalanced Audio Output Jack:

3. Audio Output Connection:a. Unbalanced Level Switch Setting Position:Make sure to match the unbalanced output setting to the device input setting. T

3. TWO 19/2-INCH UNITS RECEIVER INSTALLATIONA. Setup for single half-rack receiver1. Push the rack mount brackets (RM-11) upwards until it is firmly a

brackets (RM-12) on the outer sides of both receivers as shown in Figure 6.Figure 64. After completion, it can be rackmountedinto an EIA standard rack

4. OPERATION INSTRUCTIONS1. Turn the volume controls of the receiver and device in use to a minimum setting before turning on the microphone transmitt