CAUTION
PREAMPEFFECTS
OUT
SEND
FUSE
5A
SPEAKER JACKS PARALLELE
D
120W RMS/44V RMS 4 MIN.
BUILT UNDER U.S. PATENT NO. 5,197,102
4 8 16
SPEAKER OUTPUTS
RETURN
SWITCH
60 Hz
400 WATTS
120V
GND.
0
U
S
E
F
F
U
S
E
F
U
S
E
E
S
U
F
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, THIS APPARATUS
WARNING:
SHOULD NOT BE EXPOSED TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS. TO PREVENT THE RISK
AVIS:
ELECTRIQUE, CET APPAREIL NE DOIT PAS ETRE EXPOSE A LA PLUIE OU A L’HUMIDITE ET
AUCUN OBJET REMPLI DE LIQUIDE, TEL QU’UN VASE, NE DOIT ETRE POSE SUR CELUI-CI.
DANS LE BUT DE REDUIRE LES RISQUES D’INCENDIE OU DE DECHARGE
OF FIRE HAZARD, REPLACE WITH SAME TYPE 250 VOLT FUSE.
REMPLACER PAR UNFUSIBLE DE MEME TYPE ET DE 250 VOLTS.
REFER ALL SERVICING TO PEAVEY
AUTHORIZED SERVICE CENTER
CAUTION
ALL TUBES 12AX7A
R
A PRODUCT OF PEAVEY
ELECTRONICS CORP
.
MERIDIAN, MS MADE IN U.S.A.
10
Rear Panel
Fuse (17)
A 5 amp fuse is located within the cap of the fuseholder. It must be replaced with the same type and
value in order to avoid damage to the equipment and to prevent voiding the warranty. If the amp
repeatedly blows fuses, it should be taken to a qualified service center for repair.
WARNING: The fuse should only be replaced when the power cord has been disconnected from
its power source.
Line Cord (120 V units only) (18)
For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities.
It is not advisable to remove the ground pin under any circumstances. If it is necessary to use the 6505
without proper grounding facilities, suitable grounding adapters should be used. Greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.
Ground Switch (19)
This three position, rocker-type switch should be operated in the center (zero) position for most
applications. If hum or noise is noticed coming from the speaker enclosure(s) with the ground switch in
the center position, place the ground switch to positive or negative (+ or -) to minimize hum. Should a
hum/noise problem continue, consult your authorized Peavey Dealer, the Peavey factory or a qualified
service technician.
NOTE: The ground switch is not functional on 220/240 volt models.
Effects Send/Effects Return (20, 21)
Signals are supplied to outboard effects or signal processing units by patching from the EFFECTS SEND
[20] output into the outboard unit(s) and back into the EFFECTS RETURN [21] input using shielded cable
with 1/4" phono jacks. Only non-gain effects devices (chorus, reverb, delay, etc.) should be used in
the effects loop. Remote (on/off) selection of outboard effects devices can be achieved using the 6505
footswitch.
Preamp Out (22)
This output can be used to send a preamped signal from the 6505 to a mixing console, etc., using
shielded cable. Patching from the PREAMP OUT does not affect the normal operation of the amplifier.
17
18 19
20
21
22
(22 pages)
(3 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals