Peavey PCX-U302 User Manual download pdf (Page 6)

2. AC/DC Power Connection:

Fig. 3

Connect the AC/DC adapter cable to the DC 12V

input jack. Then plug the adapter unit into an

appropriate AC outlet as shown in figure 3. Caution:

Make sure the correct voltage is present at the AC

outlet as indicated on the AC/DC adapter.

3. AUDIO OUTPUT CONNECTION:

a. Unbalanced Level Switch Setting Position:

Make sure to match the unbalanced output

setting to the device input setting. The

incorrect setting could result in low sensitivity

level or over load distortion. Ex. (If you are

going into the “Line” input on a mixer or

amplifier then the switch should be set to the

high position. If you are going into the “Mic”

input of an amplifier or mixer then the switch

should be set to the low position.)

b. Unbalanced Output:

Connect the 1/4" phone plug of the audio

cable into the unbalanced output connector on

the back of the receiver. Connect the other

end of the cable to the proper input of the

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Peavey PCX-U302 User Manual Page 6