Peavey PCX-U302 User Manual download pdf (Page 12)

d. If the receiver output level is adjusted to a

level that is near the maximum input level of

the desired device, it will cause saturation

distortion of the device when the receiver

output level is increased due to a increase in

level by the sound source. Conversely, S/N

ratio will decrease if the receiver volume

control is adjusted too low.

5. Plug the cable of the mains unit into DC

socket on the receiver’s back panel. Thread

the cable through the cable grip as shown in

the figure below (Figure 10). The cable grip

prevents the connector from being pulled off

by accident.

Fig. 10

5. Caution

1. Since the installation of the antenna influences

the operating efficiency of the receiver, the

most important rule is to minimize the distance

as much as possible between the receiving

antenna and the microphone for the best

reception and performance.

2. The output voltage of the external DC power

supply should not be below 12V, otherwise it

will not work properly. If the voltage is over

15V some components of the receiver will be

damaged due to excessive current draw. Use

a power supply with a 1A minimum rating.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Peavey PCX-U302 User Manual Page 12